Open Microscopy Environment

I modified the OMERO Appliance and now I would like to access the omero.server in the appliance using web browser because I modified some templates in OMERO.web

Do you have any documentation on how to do this? I have seen documentation on how to access that omero.server using the omero.insight, but my changes won't be seen in there

Hi Ivan,

The OMERO Virtual Appliance is set up with port forwarding, so that it can be accessed like a service bound to a specific port of the local host. The default Virtual Appliance setup binds OMERO.web to port 8080.

The documentation located under http://www.openmicroscopy.org/site/support/omero4/users/virtual-appliance.html#omero-web outlines how to work with OMERO.web that is run from the Virtual Appliance.

I hope that solves your issue,

Regards,
Blazej